Quadra-Fire CASTILEI-MBK Manual

Also see for CASTILEI-CSB: Owner's manual Owner's manual Owner's manual installation and operation Installation manual Owner's manual

Quadra-Fire CASTILEI-MBK Manual Manual pdf 22 page image

22 7022-515G November 27, 2017CASTILE INSERTD. Igniter Replacement1. Shut down the appliance by turning down the thermostatand let the appliance completely cool down. After theappliance has cooled down, unplug it and remove theash drawer.2. The wire leads to the igniter are connected to the wireharness with 1/4 inch (6mm) male / female spadeconnectors. These wires will pull forward approximately4 to 5 inches (102mm to 127mm) through the grommetat the back of the ash drawer chamber. Disconnectthe spade connections and remove the igniter from thechamber. Loose the thumb screw and slide igniter out.3. Install new igniter into the chamber and tighten thethumb screw. Re-connect the wires to the 2 leads withthe spade connectors.4. Push excess wire leads back through the grommet, onewire at a time, to take-up the 4 to 5 inches (102mm to107mm) previously pulled out. This will keep the wiresout of the way of the ash drawer. Double check thatthe igniter wires are clear of any movement, i.e. ashdrawer, fire pot cleaning rod, cleaning slide plates, etc.5. Re-install the ash drawer and then re-install the sidepanel and re-connect the power.E. Glass Replacement1. Open the face and remove door from the applianceby lifting door off of hinge pin and lay on a flat surfaceface down.2. Using a screwdriver, tap the bottom of the rope retainerrod to push it up out of the hole. The top end of the rodwill slide up. Swing the rod toward you from the bottomand remove the rod. Repeat for other side.3. Remove old glass and replace with new glass.4. Slide the retainer rod into the top hole first, and thenline up the bottom crimped end with the hole in thedoor. The crimped end must be parallel with the glassin order to insert it into place. Figure 22.2.Figure 22.1Figure 22.2IgniterIgniter BracketThumb Screw• Glass is 5mm thick high temperature heat-re-sistant ceramic glass.• DO NOT REPLACE with any other material.• Alternate material may shatter and causeinjury.WARNINGSlide thisend in firstRope Retainer RodsGlass shipswith GasketInstalledCrimped end mustbe paralle with theglassGasket