Quadra-Fire CB1200M-MBK Owner's Manual

Also see for CB1200M-MBK: Owner's manual Installation and operation maintenance Installation manual Owner's manual

Quadra-Fire CB1200M-MBK Owner's Manual Manual pdf 34 page image

Page 34 7014-179H November 5, 2014RCB 1200 Pellet Stove2. Exhaust Blower ReplacementRemove existing blower:a. Use proper shut down procedures to shut down the appli-ance and let it completely cool and then unplug it.b. Use an 11/32" wrench or nut driver to loosen and removethe (6) nuts holding motor mount plate to the blower hous-ing on your stove.c. Remove washer from beneath the terminal ring on thegrounding wire.d. Pull motor/mounting plate from blower housing.e. Scrape off old gasketing material from blower housing.Install new blower:f. The blower and blower housing is shipped as a unit. It isnecessary to separate them at this point if you are usingthe existing blower housing already installed on the appli-ance:g. Follow steps 2 and 3 above. Discard or set aside the newblower housing.h. Carefully remove gasketing from new housing and setonto the blower housing.Re-install blower to blower housing:i. Install blower on housing ensuring that wiring exits facingthe 8 o’clock position. Place the washer and then thegrounding wire on nearest mounting plate stud.j. Use nuts removed in step b to secure blower to housing.k. Re-connect wiring (use jumper wire if necessary). Re-connect power supply.F. Baffl e Removal1. Use proper shut down procedures to shut down theappliance and let it completely cool down.2. Open right side panel and then open the door.3. The 2 baffles are located at the top inside of firebox.4. Place your hand on the baffle and slide it up and thebottom edge will fall down and then you can lift the baffleout. Repeat for the other side.1. Remove Baffle to Access Heat ExchangerTubes and Firebox Exhaust Exits1. Open the upper right side panel door and then open theglass door.2. The 2 baffles are located at the top inside of firebox.3. Place your hand on the baffle and slide it up and thebottom edge will fall down and then you can lift the baffleout. Repeat for the other side.4. Re-install in reverse order.G. Igniter Replacement1. Use proper shut down procedures to shut down theappliance and let it completely cool down and thenunplug it and remove the ash drawer.2. Follow instructions to remove the ash pan found onpage 30. Remove the access plate directly above itby removing the 2 screws just below the ash catcher.3. The wire leads to the igniter are connected to the wireharness with 1/4 inch male / female spade connectors.These wires will pull forward approximately 4 to 5 inches(102mm to 127mm). Disconnect the spade connectionsand remove the igniter from the chamber. Loosen thethumb screw and slide igniter out.4. Install new igniter into the chamber and tighten thethumb screw. Re-connect the wires to the 2 leads withthe spade connectors.5. Remove right side panel and pull wire leads back towardthe rear of the appliance to take-up the 4 to 5 inches(102mm to 107mm) previously pulled out. This willkeep the wires out of the way of the ash drawer. Doublecheck that the igniter wires are clear of any movement,i.e. ash drawer, firepot cleaning rod, etc.6. Re-install the ash drawer and side panel and re-connectthe power.IgniterIgniter BracketThumb ScrewFigure 34.1