Quadra-Fire MT VERNON E2-C Installation Manual

Quadra-Fire MT VERNON E2-C Installation Manual Manual pdf 5 page image

October 12, 2017 7080-162B 5MT VERNON E2-C• Installation and use of any damagedappliance.• Modification of the appliance.• Installation other than as instructed by Hearth & HomeTechnologies.• Installation and/or use of any component part notapproved by Hearth & Home Technologies.• Operating appliance without fully assembling allcomponents.• Operating appliance without legs attached (if suppliedwith appliance).• Do NOT Over fireOr any such action that may cause a fire hazard.WARNINGHearth & Home Technologies disclaims anyresponsibility for, and the warranty will bevoided by, the following actions:Reciprocating Saw Channel LocksHammer Phillips ScrewdriverTape Measure Plumb Line1/4” Self-Tapping Screws Framing MaterialHi-temp Caulking Material GlovesSafety Glasses Framing SquareElectric Drill & Bits (1/4”) LevelMay also need:Vent Support Straps Venting PaintTools and building supplies normally requiredfor installation, unless installing into an existingmasonry fireplace:B. Tools And Supplies Needed C. Inspect Appliance and Components• Open the appliance and remove all the parts and articlespacked inside the Component Pack. Inspect all the partsand glass for shipping damage.• Report to your dealer any parts damaged in shipment.• All labels have been removed from the glass door.• Plated surfaces have been wiped clean with a soft cloth,if applicable.• Read all the instructions before starting the installation.Follow these instructions carefully during theinstallation to ensure maximum safety and benefit.• Follow pipe manufacturer instructions for installationand air clearance requirements.Risk of Fire!Damaged parts could impair safe operation.Do NOT install damaged, incomplete orsubstitute components.WARNING