Quadra-Fire MT. VERNON E2 Series Owner's Manual

Contents

Quadra-Fire MT. VERNON E2 Series Owner's Manual Manual pdf 19 page image

August 3, 2018 7080-163D 19MT. VERNON E2-CSOFTWARE RESET:Software reset is used to erase ALL temperature events,and to return all user-adjustable software settings back totheir original factory default settings.To Perform a Software Rest:1. Verify the thermostat’s keypad is not locked.2. Move TEMPERATURE switch to OFF.3. Press and hold the UP, DOWN, and NEXT buttons allat the same time for at least 5 seconds. When the LCDdisplay screen will become fully populated let go of allbuttons at that point the screen will return to normal.The clock will have to be changed to match the current dayand time.W. Thermostat Battery ReplacementThis thermostat is powered by two “AA” Alkaline batteries.The batteries should be replaced AT LEAST once peryear to ensure reliable operation or sooner if the LO BATTappears on the display screen. The batteries are located onthe back of the thermostat’s circuit board. The front portionof the thermostat can be removed from the back half byusing the tabs on the top edge of the thermostat housing(Figure 19.1).Figure 19.1Figure 19.2 - Fullbattery iconFigure 19.3 - Lowbattery iconWhen installing new batteries, it is recommended usingonly brand new “AA” size alkaline batteries. Please verifythe polarity markings shown in the battery compartmentbefore adding batteries to the compartment. When finished,line up the front of the thermostat to the base, and firmlypress together to securely latch the front and back halvestogether properly.BATTERY GRAPHIC:Anytime time the batteries are physically present in thethermostat, there will be a visual indicator showing thelife of the battery. This will appear on the display screen(Figures 19.2 & 19.3).Shock hazard.• Do NOT remove grounding prong from plug.• Plug directly into properly grounded 3 prongreceptacle.• Route cord away from appliance.• Do NOT route cord under or in front of appliance.CAUTIONFigure 19.4CONNECT THERMOSTAT WIRES TO APPLIANCE:There is a 4 screw terminal block located on the back lowerleft corner of the stove directly above the power cord inlet.The center 2 screws are for the thermostat wires (Figure19.4).f i r e - p a r t s . c o m