Quadra-Fire MTV-E2-CSB Installation Manual

Also see for MT. VERNON E2: Owner's manual Owner's manual Installation manual Manual

Quadra-Fire MTV-E2-CSB Installation Manual Manual pdf 3 page image

October 28, 2014 7080-131D 3MT VERNON E2The Quadra-Fire Mt. Vernon E2 Pellet Stove meets the U.S. Envi-ronmental Protection Agency’s 1990 particulate emission standards.1 Important Safety InformationNOTE: Hearth & Home Technologies, manufacturer ofthis appliance, reserves the right to alter its products, theirspecifications and/or price without notice.Improper installation, adjustment, alteration, service ormaintenance can cause injury or property damage.For assistance or additional information, consult a qualifiedinstaller, service agency or your dealer.• Installation and use of any damaged appliance.• Modification of the appliance.• Installation other than as instructed by Hearth & HomeTechnologies.• Installation and/or use of any component part not approved byHearth & Home Technologies.• Operating appliance without fully assembling all components.• Operating appliance without legs attached (if supplied with unit).• Do NOT Overfire - If appliance or chimney connector glows,you are overfiring.Any such action that may cause a fire hazard.WARNINGFire Risk.Hearth & Home Technologies disclaims anyresponsibility for, and the warranty will be voided by,the following actions:• The structural integrity of the mobile home floor, ceil-ing, and walls must be maintained.• The appliance must be properly grounded to the frameof the mobile home and use only Listed pellet ventClass “L” or “PL” connector pipe.• Outside Air Kit, part OAK-3 must be installed in a mo-bile home installation.F. Non-Combustible MaterialsMaterial which will not ignite and burn, composed of anycombination of the following:- Steel - Plaster- Brick - Iron- Concrete - Tile- Glass - SlateMaterials reported as passing ASTM E 136, StandardTest Method for Behavior of Metals, in a Vertical TubeFurnace of 750° C.G. Combustible MaterialsMaterial made of/or surfaced with any of the following ma-terials:- Wood - Compressed Paper- Plant Fibers - Plastic- Plywood/OSB - Sheet Rock (drywall)Any material that can ignite and burn: flame proofed or not,plastered or un-plastered.*BTU will vary, depending on the type of fuel you use in yourappliance. Consult your Quadra-Fire dealer for best results.C. Glass Specifi cationsThis stove is equipped with 5mm ceramic glass. Replaceglass only with 5mm ceramic glass. Please contact yourdealer for replacement glass.D. Electrical Rating115 VAC, 60 Hz, Start 2.9 Amps, Run 2.45 AmpsE. Mobile Home Approved• This appliance is approved for mobile home installa-tions when not installed in a sleeping room and whenan outside combustion air inlet is provided.Model Mt. Vernon Pellet Stove E2Laboratory OMNI Test Laboratories, Inc.Report No. 061-S-83-2Type Solid Fuel Room Heater, Pellet andShelled Corn Fuel Burning TypeStandard ASTM E1509-12, ULC S627-00 and(UM) 84-HUD, Mobile Home Approved.FCC Complies with Part 15 of FCC Rules.Operation is subject to the followingtwo conditions: (1) this device may notcause harmful interference, and (2) thisdevice must accept any interferencereceived, including interference that maycause undesired operation.A. Appliance CertificationNOTICE: This installation must conform with local codes. Inthe absence of local codes you must comply with the ASTME1509-12, ULC S627-00, (UM) 84-HUD and ULC/ORD-C-1482.B. BTU & Effi ciency SpecificationsEPA Certifi ed: 1.7 grams per hourEPA Certifi cationNumber and Date:Number: 926Issued: 2014Effi ciency: 86.5%BTU Input EPA: 18,000 to 52,500BTU Output: EPA: 13,800 to 37,600Vent Size: 3” or 4” Type ‘L’ or ‘PL’Fuel: Wood Pellets & Shelled Corn