May 5, 2015 7034-277E 3MT. VERNON AEModel Mt. Vernon Pellet StoveLaboratory OMNI Test Laboratories, Inc.Report No. 061-S-68-6Type Solid Fuel Room Heater/Pellet FuelBurning TypeStandard ASTM E1509-04, ULC S627-00 andULC/ORD-C1482-M1990 Room HeaterPellet Fuel Burning type and (UM)84-HUD, Mobile Home Approved.FCC Complies with Part 15 of FCC Rules.Operation is subject to the followingtwo conditions: (1) this device may notcause harmful interference, and (2) thisdevice must accept any interferencereceived, including interference that maycause undesired operation.The Quadra-Fire Mt. Vernon AE Pellet Heater meets the U.S.Environmental Protection Agency’s emission limits for pelletheaters sold after May 15, 2015.This pellet heater needs periodic inspection and repair forproper operation. It is against federal regulations to operatethis pellet heater in a manner inconsistent with operatinginstructions in this manual.EPA Certification #: 970-14EPA Certified Emissions: 1.7 grams per hour*LHV Tested Efficiency: 76.9 %**HHV Tested Efficiency: 71.2 %***EPA BTU Output: 12,500 to 40,200 / hr.****BTU Input: 16,800 to 53,300 / hr.Vent Size: 3 or 4 inches, “L” or “PL”Hopper Capacity: 75 lbs.Fuel Wood Pellets* Weighted average LHV efficiency using data collected duringEPA emissions test.**Weighted average HHV efficiency using data collected duringEPA emissions test.***A range of BTU outputs based on EPA Default Efficiency andthe burn rates from the low and high EPA tests.****Based on the maximum feed rate per hour multiplied byapproximately 8600 BTU’s which is the average BTU’s from apound of pellets.1 Important Safety InformationNOTE: Hearth & Home Technologies, manufacturer ofthis appliance, reserves the right to alter its products, theirspecifications and/or price without notice.Improper installation, adjustment, alteration, service ormaintenance can cause injury or property damage.For assistance or additional information, consult a qualifiedinstaller, service agency or your dealer.Quadra-Fire is a registered trademark of Hearth & HomeTechnologies.• Installation and use of any damaged appliance.• Modification of the appliance.• Installation other than as instructed by Hearth & HomeTechnologies.• Installation and/or use of any component part not approved byHearth & Home Technologies.• Operating appliance without fully assembling all components.• Operating appliance without legs attached (if supplied with unit).• Do NOT Overfire - If appliance or chimney connector glows,you are overfiring.Any such action that may cause a fire hazard.WARNINGFire Risk.Hearth & Home Technologies disclaims anyresponsibility for, and the warranty will be voided by,the following actions:C. Glass Specifi cationsThis stove is equipped with 5mm ceramic glass. Replaceglass only with 5mm ceramic glass. Please contact yourdealer for replacement glass.D. Electrical Rating115 VAC, 60 Hz, Start 5 Amps, Run 1.25 AmpsE. Mobile Home Approved• This appliance is approved for mobile home installa-tions when not installed in a sleeping room and whenan outside combustion air inlet is provided.• The structural integrity of the mobile home floor, ceil-ing, and walls must be maintained.• The appliance must be properly grounded to theframe of the mobile home and use only Listed pelletvent Class “L” or “PL” connector pipe.• Outside Air Kit, part OAK-ACC must be installed in amobile home installation.NOTICE: This installation must conform with local codes. Inthe absence of local codes you must comply with the ASTME1509-04, ULC S627-00, (UM) 84-HUD and ULC/ORD-C-1482.A. Appliance CertificationB. BTU & Effi ciency Specifications