Quadra-Fire QFI30FB-IFT Homeowner And Installation Manual

Also see for QFI30FB-IFT: Owner's manual Owner's manual

Quadra-Fire QFI30FB-IFT Homeowner And Installation Manual Manual pdf 18 page image

Quadra-Fire • QFI30FB-IFT, QFI35FB-IFT Installation Manual • 2555-980 Rev. C • 9/18188 Electrical InformationWARNING! Risk of Shock! Replace damaged wire withtype 105 ºC rated wire. Wire must have high temperatureinsulation.Electrical Service and RepairWARNING! Risk of Shock! Label all wires prior to dis-connection when servicing controls. Wiring errors cancause improper and dangerous operation. Verify properoperation after servicing.• Refer to Service Parts section of appliance Owner’sManual for replacement part information.A. General InformationWARNING! Risk of Shock or Explosion! DO NOT wire110-120 VAC to the valve or to the appliance wall switch.Incorrect wiring will damage controls.NOTICE: This appliance must be electrically wiredand grounded in accordance with local codes or, in theabsence of local codes, with National Electric CodeANSI/NFPA 70-latest edition or the Canadian ElectricCode CSA C22.1.• This appliance comes with a 110-120 VAC cordassembly. This is required for proper operation of theappliance (IntelliFireTM Touch Ignition). An outlet box maybe installed in a bottom back corner of the existing solidfuel masonry or factory built fireplace to plug in the cordassembly, or the supplied power cord may be routed outonto the hearth to a nearby outlet.• A 110-120 VAC circuit for this product must be protectedwith ground-fault circuit-interrupter protection, incompliance with the applicable electrical codes, whenit is installed in locations such as in bathrooms or nearsinks.• Low voltage and 110-120 VAC voltage cannot be sharedwithin the same wall box.• In some instances, the spark ignition of the fireplace maycause intermittent, non-damaging, interference duringthe lighting sequence with a TV plugged into the samecircuit. It is recommended that the fireplace and TV usedifferent circuits to mitigate the interference potential.If interference is occurring on the same circuit, the useof surge protectors may help alleviate the interference.NOTICE: DO NOT wire 110-120 VAC to wall switch.Figure 8.1 Electrical Outlet DetailELECTRICAL OUTLET LOCATIONSMASONRYMASONRYAPPLIANCERECOMMENDED