Quadra-Fire QFP 30 Operation & Maintenance Manual

Quadra-Fire QFP 30 Operation & Maintenance Manual Manual pdf 34 page image

QFP 30 Direct Vent Gas FireplacePage 34 03/21/01 #250-6120LIGHTING INSTRUCTIONSLIGHTING INSTRUCTIONSA. This appliance has a pilot that must be lit manually. When lighting the pilot,follow these instructions exactly.B. BEFORE LIGHTING, smell around the appliance areas for gas. Be sure tosmell next to the floor because some gas is heavier than air and will settleon the floor.WHAT TO DO IF YOU SMELL GASDo not try to light any applianceDo not touch any electric switch; do not use any phone in your buildingImmediately call your gas supplier from a neighbor’s phone. Follow the gassupplier’s instructions.If you cannot reach your gas supplier, call the fire department.C. Use only your hand to push in or turn the gas control know. Never use tools. If theknob will not push in or turn by hand, don’t try to repair it, call a qualified servicetechnician. Force or attempted repair may result in a fire or explosion.D. Do not use this appliance if any part has been under water. Immediately call aqualified service technician to inspect the appliance and to replace any part of thecontrol system and any gas control which has been under water.LIGHTING INSTRUCTIONS1 STOP! Read the safety information above on these instructions.2. Set the thermostat to the lowest setting ( if applicable) and turn off the switchat the control panel.3. Disconnect power from appliance.4. Remove fascia.5. Open the door of the appliance with spring latches located at the top andbottom of the door.6. Wait five (5) minutes to clear out any gas. Smell for gas, including near the floor.If you smell gas, STOP! Follow “B” of the safety information above. If you don’tsmell gas, go to the next step.7. Push gas control knob in and turn to “PILOT” position. NOTE: Knob cannot beturned from “PILOT” to “OFF” unless knob is pushed in slightly. Do not force.8. Press down on the gas control knob in “PILOT” position and simultaneouslypress piezo igniter on the control panel. (This may take many repetitions forlighting.)9. The pilot should be visible through the door.10. After the pilot is lit, continue holding control knob down for Approximately 30seconds. Release knob and it will pop back up.Pilot should remain lit. If it goes out, repeat steps 5 through 9.If the knob does not pop up when released, stop and immediately call your servicetechnician or gas supplier.If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” andcall your service technician or gas supplier.11. Close appliance door.12. Turn gas control knob to “ON”.13. Turn burner switch on the control panel to “ON”. If thermostat is to be used, leaveswitch in “OFF” position and set the thermostat to desired setting.14. Reconnect electrical poser to appliance.TO TURN OFF GAS TO APPLIANCE1. Set the thermostat to lowest setting.2. Turn off all electric power to the appliance if service is to be performed.3. Push in gas control knob slightly and turn clockwise to “OFF position.Do not force.