Quadra-Fire QV36DB Installer's Manual

Contents

Quadra-Fire QV36DB Installer's Manual Manual pdf 20 page image

23Quadra-Fire • QV36DB • 2017-900 Rev. C • 5/05Figure 25. Ceiling Firestop (Ceiling Side)If the area above the ceiling IS an attic, position and securethe firestop on top of the previously framed hole.NOTE: Keep insulation away from the vent pipe at least1 inch (25mm).Figure 26. Attic FirestopJOISTCEILING FIRESTOPCEILINGNAILS (4 REQUIRED)CEILINGCEILING FIRESTOPRAFTERNAILS (4 REQUIRED)NOTE: There must be NO INSULATION or othercombustibles inside the framed firestop opening.Figure 27. Trapezoid Termination Cap7 1/4”(184mm)!C. Vent TerminationRefer to Cinch Pipe and Termination Cap installation in-structions.Horizontal Termination• The termination kit should pass through the wall firestopsfrom the exterior of the building.• Adjust the termination cap to its final exterior positionon the building and interlock the flue sections.!WARNING: VENTING TERMINALS SHALL NOTBE RECESSED INTO A WALL OR SIDING. VENTTERMINATION CLEARANCES MUST BE FOL-LOWED TO AVOID FIRE DANGER. SEE VENT TER-MINATION MINIMUM CLEARANCES DIAGRAM ONFOLLOWING PAGE.WARNING: THE TERMINATION CAP MUST BEPOSITIONED SO THAT THE ARROW IS POINTINGUP.