Quadra-Fire TREKKER-CSB Owner's Manual

Also see for TREKKER-CSB: Installation manual Owner's manual

Quadra-Fire TREKKER-CSB Owner's Manual Manual pdf 20 page image

20 7080-166B April 18, 2018TREKKERI . Combustion/Exhaust Blower Replacement1. Follow the proper shut down procedures.2. Remove the right side panel by loosening the 2 screwsusing a Phillips head screw driver or wrench. Figure20.1.3. It is not necessary or recommended to remove the hous-ing to replace or service the combustion blower. Youonly need to remove the motor and impeller.4. Disconnect the wire from the control board connectionand hall effect switch/housing.5. Using an 7mm socket wrench or nut driver, loosen thenuts securing the motor and impeller to the housing.6. Holding the motor, rotate the mounting plate count-er-clockwise and remove motor and impeller.7. If the gasket between housing and motor is damaged itwill have to be replaced. A gasket is included with thereplacement blower.8. Re-install in reverse order.Figure 20.1