Quadra-Fire VOYA-GRAND-MBK Owner's Manual

Also see for VOYA-GRAND-MBK: Installation manual Owner's manual Installation manual Owner's manual Owner's manual

Quadra-Fire VOYA-GRAND-MBK Owner's Manual Manual pdf 21 page image

July 8, 2015 7075-208D 21VOYAGEUR GRANDA. Glass Replacement - Door Assembly(Replace with 5mm ceramic glass only)1. Ensure that the fire is out and the appliance is cool tothe touch.2. Protect a table or counter top with padding or towels.Protect your hands and wear gloves to prevent injury.3. Remove the door with the broken glass by lifting the doorup and off of the hinges.4. Lay door face down on a table or counter making surethe handle hangs over the edge so the door lays flat, ona soft surface.5. Remove the screws from each glass retainer and removethe glass. (If screws are difficult to remove, soak withpenetrating oil first).6. Center the glass with edges evenly overlapping theopening in the door, (i.e. same space top and bottom,left and right sides).7. Replace the glass retainers. Be careful not to crossthread the screws.8. Tighten each retainer just a few turns until each issecured. Check again for centering of glass in doorframe. Continue to tighten each retainer alternately, afew turns at a time, until the glass is secure. DO NOTOVERTIGHTEN - can cause glass to break.9. Replace the door on the appliance.Quadra-Fire appliances are equipped with ceramic super heat-resistant glass, which can only be broken by impact or misuse.WARNING! Risk of Fire or Injury!Use only glass that is specified in the manual, DO NOTreplace with any other material. Glass breakage will occur.CAUTION!Handle glass with care.• Inspect the gasket to ensure it is undamaged.• Do NOT strike, slam or scratch glass.• Do NOT operate appliance with glass & door assemblyremoved.• Do NOT operate with glass cracked, broken or scratched.B. Blower Replacement1. The grille on the blower access assembly is hinged. Swingthe grille downward to expose the 2 screws. Figure 21.1.2. Remove the 2 screws from the blower access assemblyand slide assembly away from the appliance.3. Disconnect the wires from the blower.4. Remove the 2 screws from the hold down bracket and pullthe blower and bracket forward.5. Remove the blower from the hold down bracket.6. Remove the protection guards from each end of the blower.7. Re-install in reverse order. Be certain that the hold downbracket’s screws are completely seated in the grommets.Insert the locating tab in the hold down bracket into theplacement slot.Figure 21.1Shock Risk.• Do NOT remove grounding prong from plug.• Plug directly into properly grounded 3 prongreceptacle.• Route cord away from appliance.• Do NOT route cord under or in front of appliance.CAUTIONBlower AccessAssemblyGrille hingesdownwardRemove Screws &Pull Access Assemblyaway from InsertHold DownBracketRemove Screws from Hold DownBracket and Pull Blower AssemblyForward. Do not Remove Blower fromthe Hold Down BracketPlacement SlotBlower Control PlateSnap Disc Bracket5 Service Parts Replacement