August 3, 2015 7063-513E 21VOYAGEURCorner BracketsFigure 21.2Figure 21.3Strain Relief forBlower Cord andCover Plug for holein each sideSecure 2 Sides to TopMounting TabsSlide into Slotson Firebox FaceSecure toFirebox FaceHeat Deflector5/16 NutsAttachmentBar5/16 BoltsFigure 21.1E. Securing Appliance to Stove Pipe/Liner1. Once you have the appliance in place and secured,remove the tube channel assembly, baffle board andceramic blanket.2. Reach up through the flue opening and grab the attach-ment bar and pull down inside flue opening. Figure 21.1.2. Insert the 5/16 bolts inside the cast flue and through thechimney mounting bar. Securely tighten the nuts. Fas-teners are provided.3. Re-install the tube channel assembly, baffle board,ceramic blanket and baffle protection channel.F. Surround & Trim Kit InstallationStandard Size: 43 in. W x 31 in. HLarge Size: 51 in. W x 34 in. H1. Lay surround face down on a protected surface to pre-vent scratching.2. Using a 4 to 6 inches long Phillips head screw driverattach the side surrounds to the top surround using (2)#8 sheet metal screws on each side provided with the kit.Figure 21.3.3. Lay the trim face down and place the corner brackets intoposition.4. Using a standard flat screw driver tighten the cornerbrackets. Figure 21.2.5. Slide the assembled trim set over the surround set. andthen over the appliance matching the mounting tabs onthe side pieces with the slots on the appliance. Figure21.3.6. Align the 2 screws in the top surround piece to the 2alignment holes on the appliance top. Secure in place.Figure 21.3.7. Use the strain relief in the surround side for blower cordinstallation and use the cover plug to insert into the holewhere the blower cord is not installed.