Quadra-Fire Yosemite YOSEMITE-MBK Installation & Operation Manual

Also see for YOSEMITE-MBK: Owner's manual Owner's manual Owner's manual

Quadra-Fire Yosemite YOSEMITE-MBK Installation & Operation Manual Manual pdf 14 page image

RPage 14 7004-187F September 1, 2008Yosemite Wood Stove6Support Plate & ClampListed RigidStainless LinerStainless SteelFlex SectionStainlessConnectorPipeCarry StovepipeAbove the LinerDamper Plate isRemoved orFastened in OpenPositionUse Damper Adapter orSeal With Sheetmetaland SealantCleanoutStainless Tee with CleanoutFireclay liner 5/8"(16mm) Minimum orEquivalent.Heat ShieldFirst, make the frame for the thimble, ensuring it is no smallerthan 14 inches (356mm) square to maintain a 2 inch (51mm)air space around the chimney section.Attach the wall spacer to the chimney side of the frame.Then insert the frame into the opening, toe nailing it to thewall studs. Install the wall band in the framing to secure thechimney section in place.Insert a single section of chimney connector into the chimneythrough the wall band, being sure it does not protrude into thechimney beyond the edge of the chimney flue lining.Apply high temperature furnace cement to the end of thechimney section and install it over the connector, through thewall spacer. Tighten the wall band to hold the chimney sectionfirmly in place and against the chimney.Install the trim collar on the outside of the opening. A 1 inch(25mm) air space between the connector and the chimneysection must be maintained.During installation a 2 inch (51mm) air space to the woodframing is maintained. Do not fill this space with insulation.Insulation in this air space will cause a heat buildup whichmay ignite the wood framing.SOLID PACK CHIMNEY WITH METALSUPPORTS AS A THIMBLE (CONT'D)Chimney FlueLinerFireclayLiner orEquivalentMasonry ChimneyConstructed to NFPA 211Wall SpacerWall BandTrim CollarChimneyConnector1" (25mm) AirSpace to ChimneySectionMin. Clearance2" (51mm)Min. Chimney Clearanceto Wall Spacer andCombustibles - 2" (51mm)Chimney SectionTrim CollarChimney Sectionwith 2" (51mm)Clearance toCombustiblesChimneyConnectorFire ClayFlue Linerwith AirspaceMasonryChimneyWall Band toSecureChimneySectionWood Studs Used forFraming - Spaced 2"(51mm) clearancefrom MasonryWall SpacerFigure 14ACONNECTION TO A MASONRYFIREPLACEThere are several kits available to connect the stove toa masonry fireplace. Look for a listed kit. The kit is anadapter which is installed at the location of the fireplacedamper. The existing damper may have to be removed toallow installation of the kit.The key points of this type of stove connection are: 1) thatthe connector pipe must extend up the chimney above wherethe fire clay liner starts, and 2) the areas of the kit installationand penetration should fit tightly and be sealed with hightemperature furnace cement unless the kit’s instructions stateotherwise. (See Figure 14C). The tight fitting installationaids the proper draw of the chimney.Horizontal Flue Heat Shield, AccessoryPart HTSHLD-7006 is required for rear ventinstallations.Figure 14BFigure 14C