Quadro Quadro2x2 Installation Manual
                                                         | |
Contents
| 
Quadro6L/4L/2x2 Manual I: Installation Guide Step 2: Configuring the QuadroQuadro6L/4L/2x2; (SW Version 5.3.x and higher) 22DHCP Settings for the LAN InterfaceIf the DHCP server is enabled, the Quadro will automatically assign dynamic IP addressesto the stations connected to its LAN port.If you didn’t change the default LAN IP address of the Quadro, you also may leave the de-fault values for the IP Address Range. Make sure your connected LAN devices belong tothe same network as the LAN port of your Quadro.Please Note: Make sure there is only one DHCP server on the LAN, otherwise, unpredict-able network behavior can occur.Fig. l- 19: DHCP Settings for the LAN Interface pageClick on Next to display theRegional SettingsRegional Settings page.If your Quadro is located outside of the United States, it is important to properly configureyour line connections to the PSTN in your location.Fig. l- 20: Regional Settings pageProper configuration of Regional Settings is important for the functionality of the voicesubsystem. The Regional Settings determine the proper telephony parameters on the LINE |
Related manuals for Quadro Quadro2x2
manualsdatabase
Your AI-powered manual search engine