Qualcast HST-1003A Assembly Manual
              | |
98Customer Helpline 0845 034 2279www.gardenservicecentre.co.ukCustomer Helpline 0845 034 2279www.gardenservicecentre.co.ukStep 1 - Commissioning (continued)Preparing to Operate the Petrol RotavatorStep 2 - Filling with fuelPreparing to Operate the Petrol RotavatorWARNING! Danger of injury! Fuel is explosive!- Turn off and cool the motor down before filling the tank with fuel.- You must observe all safety instructions relating to handing fuel.Risk of device damage!The device is supplied without motor oil.Before operating, you must fill it with motor oil.– Unscrew the tank cap (C) and remove it.– Pour in the fuel carefully. Avoid spilling!– Check the seal inside the tank cap for damage and replace it if necessary. Replace a damagedseal immediately!– Screw the tank cap on firmly by hand.Fuel: Unleaded gasoline 90# or above.1d Rotavator assemblyRemoving rotavator assembly:– Loosen and remove the spring pin (A).– Remove the implement from the axle.1e Front support wheelThe front support wheel makes it easier to move the device. When rotovating , it must be foldedupwards.– Pull the front support wheel from its rest position.– Fold the front support wheel upwards and let it engage.1f Draw barThe device’s forward motion is braked by means of the draw bar. The desired rotovating depth isachieved by pushing the draw bar into the soil at different levels. Setting the draw bar:– Pull out the R/clip (B) and pin.– Set the draw bar to the desired height.– Insert the pin again and secure it with the R/clip.Step3 - Filling with engine oil– Unscrew the motor oil filling bolt (D) and remove it.– Carefully pour in motor oil (approx.600 ml). Avoid spilling!– Tighten the motor oil filling bolt again by hand.Engine oil: SAE 10W-30 gradeNOTE! The appliance is supplied without engine oil. Fill engine oil before commissioning withoutfail.1d 1e1f BCDA |
Related manuals for Qualcast HST-1003A
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine