Quantum LTO 1U Quick Start Manual

Also see for 1U: Install guide Installation guide Getting started guide

Contents

connecting the scsi and power cables

Quantum LTO 1U Quick Start Manual Manual pdf 2 page image

1U Rackmount Quick Start Guide2Connecting the SCSI and Power Cables01 Shut down and turn off the selected host server. Turnoff all attached accessory devices, such as printers andother SCSI devices.2 On the back panel of the 1U Rackmount, connect oneend of the supplied external SCSI cable to either of theSCSI connectors on the same side of the 1U Rackmountas the installed tape drive. See figure 1.3 Connect the supplied SCSI terminator to the adjacentSCSI connector on the back panel of the 1U Rackmount.See figure 1.4 Connect the other end of the external SCSI cable to thehost.5 Connect the power cable to the power receptacle onthe back panel of the 1U Rackmount. See figure 1.6 Each SCSI device must have its own unique ID. Changethe SCSI ID if necessary. See figure 1.7 Plug in the power cable to the nearest properlygrounded power outlet.8 Turn on the power switch on the back panel of the1U Rackmount.9 Turn on drive power by pressing the power button onthe front panel of the 1U Rackmount. The green powerLED should illuminate.10 Turn on any other devices you turned off earlier.11 Turn on the host server.Figure 1 Back PanelConfigurationNOTE: Any time you change the SCSI ID, you mustturn the tape drive power off and then back onby pressing the power button on the front panelof the 1U Rackmount.PowercableSCSI cableSCSI IDswitchSCSITerminatorInstalling a Second Tape Drive 0Follow these instructions to install a second tape drive or toreinstall a tape drive after it has been removed.Required Tools 0#1 and #2 PHILLIPS® screwdriversAdditional RequiredEquipment 0• (1) Tape drive• (1) External SCSI cable• (1) SCSI terminatorInstructions 01 Turn off 1U Rackmount drive power by pressing thepower button on the front panel.2 Turn off the power switch on the back panel of the 1URackmount.3 Disconnect the power cable from the back panel of the1U Rackmount.4 Remove the 1U Rackmount from the the equipmentrack. Place the 1U Rackmount on a clean, stable, flatsurface.CAUTION: Before performing this procedure, you mustturn off the 1U Rackmount and disconnect it from itspower source.