Scalar i500 Advanced Reporting InstructionsDocument 6-01894-02October 20086 Configuring the Media Integrity Analysis Report• Selected Drive by Physical SN — The report chart is based on an individualtape drive identified by its physical drive serial number.• Selected Partition — The report chart is based on an individual partition inthe physical library.3 Click Next.The report is generated and appears on the screen.Configuring the Media Integrity Analysis Report 01 From the library menu bar, select Reports > Advanced Reporting > Media IntegrityAnalysis.The Media Integrity Analysis Report configuration page opens. This may take severalminutes.2 Configure the report by specifying the following:• Range — Specifies the range of time covered by the report. Choose Last 7 days;Last 4 weeks (default); Last 3 months; or All History (as far back as there is data inthe log file).• Attributes— Specifies which values are included in the report, and how they arecombined. Select in any combination, including all (default) and none. If youselect no attributes, the chart displays the TapeAlert count for the selectedGrouping.• Cartridge Barcode — All relevant tape cartridges.• Drive Physical SN — All relevant tape drives.• TapeAlert — The TapeAlert flags that were issued. For a description of allTapeAlert flags, see the online help or the Scalar i500 User’s Guide.• Chart — How the data is displayed in the chart. Choose Area, Bar (default), Line,or Pie.• Type — The chart type. Select one of the following:• Rollup (default) — Displays the number of TapeAlerts for the combination ofGrouping and Attributes you selected.• Trend — Shows the occurrence of TapeAlerts over time.• Grouping— Specifies which drive(s) or tape cartridge(s) on which to base thereport. Choose one of the following:• All (default) — All tape drives and tape cartridges for which a TapeAlert wasissued during the specified range.• Selected Drive by Physical SN — An individual tape drive. Only tape driveswhich issued a TapeAlert during the specified range appear in the report.Note: Refer to the Scalar i500 User’s Guide for an explanation of thelocation coordinates.