Quantum StorNext QD7000 Hardware Manual

Also see for StorNext QD7000: Replacing Guide Replacing Guide Replacing Guide Site planning guide Replacing Guide

Contents

Quantum StorNext QD7000 Hardware Manual Manual pdf 27 page image

Your passive SFP transceivers might look slightly different from the one shown. The differencesdo not affect the performance of the SFP transceiver.73136211. Copper cable2. Passive SFP transceiverNote: Make sure that the passive SFP transceiver installs with an audible click.3. Insert the passive SFP transceiver into the port in which the copper cable will be installed.Installing an RJ-45 cable for iSCSI connectionsFor iSCSI connections, you must install RJ-45 connectors for cables. Some 10-Gb/s iSCSIconnections use optical cables with SFP+ connectors or twin-ax passive copper cables.About this taskAttention: Possible hardware damage – To prevent electrostatic discharge damage to the shelf(tray), use proper antistatic protection when handling tray components.Steps1. Put on antistatic protection.2. Verify that you have the correct cables for your iSCSI connections by comparing them to thecable shown in the following figure.1. RJ-45 connector2. iSCSI cableCabling concepts and best practices | 19