Smart LTE Module SeriesSmart EVB G2 User GuideSmart_EVB_G2_User_Guide 53 / 59Inserting USB into USB interface after power supply is provided can also turn on the module.Communication Via USB or UART Interface5.2.5.2.1. Communication via USB Interface1. Power on the module according to the procedures mentioned in Chapter 5.1.2. Connect Smart EVB G2 and the PC with USB cable through USB interface and then run the USBflash drive on PC to install the USB driver and ADB driver. The USB port numbers can be viewedthrough the PC’s Device Manager, shown as below.Figure 49: USB COM Ports3. Open CMD tool: “START” “All Programs” “Accessory” “Command Prompt”.4. Use the “adb shell” command to make the module enter into ADB mode. Then customers can useUSB ADB interface for test.NOTE
