Quest Technologies MICRO-15 Instructions For
                | |
Minimum noise levels are either at the bottom of the range or are at thenoise floor of the instrument. For readings which do not have a lower thresholdthe accumulated noise will be at these levels.Crest factor is an almost meaningless term for instruments with crest factorsin excess of 30 dB. The MICRO-15 is capable of measuring pulses as short as 1millisecond, with a peak amplitude of 143 dB and a background level of 80 dB.This is a pulse range of 63 dB. The crest factor would depend on how often thispulse occurred but could be greater than 60 dB.ACCESSORIESModel WS-5 WindscreenRefer to page 18 for instructions on using the windscreen with the MICRO-15 microphone.58-863 Microphone BoomRefer to page 17.TripodQuest supplies two tripod models for use with the MICRO-15 as an areamonitor.PrintersThe MICRO-15 can be used with a serial, 600 baud printer.Service PolicyThe Quest product you have purchased is one of the finest acoustic instru-ments available. It is backed by our full one year warranty which seeks completecustomer satisfaction. This is your assurance that you can expect promptcourteous service for your equipment from the entire Quest service organization.Should your Quest equipment need to be returned for repair or recalibration,please contact the Service Department at (800)245-0779 (USA) or Fax (262)567-4047 for a Return Authorization Number. The RA number is valid for 30 days,and must be shown on the shipping label and purchase order/cover letter. If youare unable to return instruments in that time call for a new RA number. Send itprepaid and properly packed in the original shipping carton directly to QuestTechnologies, 1060 Corporate Center Drive, Oconomowoc, WI 53066 U.S.A.Repair or replacement work done under warranty will be performed free ofcharge, and the instrument will be returned to you prepaid. Your copy or aphotocopy of the Quest Registration Card will serve as proof of warranty shouldthe factory require this information.If for any reason you should find it necessary to contact the factory regardingservice or shipping damage, please direct your calls or letters to the attention ofthe Service Manager, Quest Technologies, (262) 567-9157 or (800) 245-0779.Office hours are from 7 AM to 6 PM (Central Standard Time) Monday throughFriday.For service or recalibration outside the U.S.A., please contact your localQuest Dealer or fax Quest U.S.A. at 1-262-567-4047. |
Related manuals for Quest Technologies MICRO-15
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine