Quickie 2 Owner's Manual

Also see for 2: Owner's manual User instruction manual & warranty Owner's manual Owner's manual

Quickie 2 Owner's Manual Manual pdf 21 page image

I X .3. Wheel Base Width AdjustmentAdjusting the wheelbase width allows the rider the option to move the wheels closer or further awayfrom the hips. It also compensates for camber adjustment and gives the proper wheel spacing to maxi-mize pushing efficiency.Adjust the wheelbase width by:a. Loosen the nuts and reposition the axle sleeve (A) to the desired width.b. Retighten nuts.4. Seat Height AdjustmentSeat height can be adjusted by moving the axle plate vertically in the predrilled frame holes (B). Thisadjustment allows a 3.375" vertical seat height adjustment.NOTE– A front caster adjustment should be made to correspond with any change in seat height.T. WHEEL LOCKSThe Quickie 2 wheelchair is shipped with one of four types of wheel locks. Wheel locks are installed at thefactory unless you have requested otherwise.Use a torque setting of 144 in.-lbs. when setting up wheel locks.1. High-Mount Push-to-Lock or Pull-to-Lock , Wheel Locks Adjustmenta. Using a 3/16 inch hex key, turn one of the screws (C) in the clamp counterclockwise one-quarterturn.b. Repeat the same process with the second of the two screws.c. Alternately loosen the screws (two turns each) until both screws are removed.d. Slide clamp toward the rear wheel until the wheel lock is embedded into the tire to preventwheel movement, when in the locked position.e. Tighten screws to 115 in-lbs.2. Ergo Scissor Wheel Locks or Compact Wheel LocksLoosen the screws (C) on the top of each clamp using a 3/16 inch hex key. Slide assembly toward rearwheel until clamp embeds into tire to prevent wheel movement when in locked position. Adjust angle posi-tion. Tighten screws to 115 in-lbs.NOTE– Clamp and wheel lock may need to be rotated to clear frame tubing.3. Unilateral Wheel LockUnilateral wheel lock may be mounted either to the right or left side of the wheelchair frame.Loosen the screws (C) on the top of each clamp using a 3/16 inch hex key. Slide assembly toward rearwheel until clamp embeds into tire to prevent wheel movement when in locked position. Adjust angle posi-tion. Tighten screws to 115 in-lbs.39363538373739CCC38B36A35E N G L I S H21 109881 Rev. B