Quickie Q7 Adjustable Owner's Manual

Also see for Q7 Active Rigid (welded): Owner's manual Owner's manual

Quickie Q7 Adjustable Owner's Manual Manual pdf 21 page image

112786 Rev. F21ENG LIS H IX. DEALER SERVICE AND ADJUSTMENTJ. ANTI-FLUTTER KIT INSTALLATION1. Remove fork assembly from chair. This may or may not require the removal of the casterwheel.2. Insert anti-flutter bushing (A) into the slot (B) at the rear of the fork ensuring the tab goesbetween the ends of the snap ring and between the bearings.3. Install clamp (C) over the top of the fork assembly inserting the inside tab (D) in the frontslot (E).4. Gently flex the clamp tabs (F) apart to allow it to slide over the recently installed bushing (A).5. Squeeze the tabs (F) back together and install the sockety head cap screw (G) into the clamp,insure threads are properly aligned and lightly tighten using a 3mm hex key.K. FOOTREST HEIGHT ADJUSTMENTWARNINGThe footrest is an integral part of the frame. Chair should not be riddenwithout a footrest.To adjust the height of your footrest, loosen the screw (H) on both footrest clamps. Slide thefootrest up or down to the new desired height and tighten the two set screws. Use a MAX torquesetting of 62 in-lbs (7 Nm). (Frame damage may occur if overtightened.) It is recommended that youmaintain a minimum of 2.0 inches (5 cm) between the lowest point on the footrest and the floor (I).This will provide adequate clearance for uneven surfaces and prevent damage to your footrest.Flip-up FootrestTo adjust the angle of the Flip-up Footrest, loosen two bolts (J) and rotate the footrest angle stopbracket. Once positioned, retighten bolts (J) to 92 in-lbs. For certain narrow widths, only one boltwill be present.High Mount Footrest Mount1. Loosen all four socket heads (K) on both sides of the chair.2. Slide footrest to desired height.3. Tighten socket to 62 in-lbs on both sides.39383736383935343336373839Rear of Fork33BACK OF FORK3435Rear of ForkABCDEFIGHJAFK