Operation Manual - PortQuidway S3000-EI Series Ethernet Switches Chapter 2 Link Aggregation ConfigurationHuawei Technologies Proprietary2-2Table 2-1 Aggregating Ethernet portsOperation CommandAggregate Ethernet ports link-aggregation port_num1 to port_num2 { both |ingress }Remove a configured link k-aggregation { master_port_num | all }aggregation undo linMbps speed, full duplex), or 1000M_FULL (1000Mbps speed,2.3 DispNote that the Ethernet ports to be aggregated can not work in auto-negotiation modeand must work in the same mode, which can be 10M_FULL (10Mbps speed, fullduplex), 100M_FULL (100full duplex), otherwise, they cannot be aggregated.lay and Debug Link AggregationAfter the above configuration, execute display command in any view to display therunning of the link aggregation configuration, and to verify the effect of theconfiguration.Table 2-2 Display the information of the link aggregationOperation CommandDisplay the information ofthe link aggregation display link-aggregation [ master_port_num ]2.4 Link Aggregation Configuration ExampleI. Networking requirementsegation commands to aggregate several portsoming payload balance among all the member ports.ally used for Trunk ports. Since the Trunk port allowso pass through, the heavy traffic needs balancing amongis connected to the Ethernet Switch (Switch B) in theupstream via the aggregation of three ports, Ethernet0/1 through Ethernet0/3.The following example uses the link aggrand implement the outgoing/incThe link aggregation is typicframes from several VLANs tall the ports.Ethernet Switch (Switch A)