Quintex QV Series Operation Manual
Also see for QA Series: Operation manual
                                                      | |
Contents
| 
Betriebsanleitung / Operation manualVerteiler mit Klemmen / Terminal box________________________________________________________________________________________________________________________________________________________________________________________________________________________Version 08/2018 Seite/page 26/5412. CommissioningElectrical equipment for a hazardous area must be selected according the conditions to bedetermined for the individual installation conditions. Operating the equipment may only becarried out in undamaged and clean condition. Electrical installations have to be checkedbefore first use and in regular intervals by qualified electrician.Please check before commissioning:• Device properly installed,• Enclosure is not damaged,• Connection made properly,• Cable installed and wired correct,• All screws tightened,• Function is OK.13. Operation, service & maintenanceThe operator of an electrical plant in hazardous areas must guarantee that all devices arein good condition. He has to operate these devices and do the maintenance work withinthe allowed parameters (please notice EN 60079-14 and EN 60079-17).Maintenance & Service work must be made by trained staff only.It´s only allowed to use original spare parts (sealing and cable glands) if replacement isnecessary. Damaged parts must be replaced immediately.The applicable laws and regulations must be considered before restarting. Beforemaintenance and/or troubleshooting the safety regulations have to be considered.WARNING – DO NOT OPEN WHEN ENERGIZED !DANGERDeath or severe injury because of usage not in accordance with regulations.Please operate the terminal box only in the applicable technical limitsMaintenanceThe operator of the terminal box has to keep them in good condition, operate it properly,monitor and clean it regularly.• Visual inspection of the enclosure for damage.• Check sealing effectiveness.• Replace old or damaged sealing with new original seals.• Check if terminals, cables and line bushings are fastened. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine