Package ContentsWarnings and Cautions1of2Assembly Instruction Sheet #IS-DE8959IB _R1For Style DE8959IB2017 QuoizelInc.Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We stronglyrecommend that a licensed, professional electrician perform the installation.Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.A Crossbar Assemblyx 1Please go to for product cleaning tips. Go to the selection.(2) B10 Candelabra Base bulbs 60W Maximum.20-30 minutesIdentify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts arepresent. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacementparts.www.quoizel.com Care + MaintenanceLight Source:Estimated Assembly Time:Preparation:Fixture can only be mounted in the direction indicated on page 2.Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.CFinialAssemblyx 1Thank you for purchasing a Quoizel product.Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184or visit us on-line at www.quoizel.comBAlternateMountingscrewx 2STEP 1 Remove Styrofoam-A. Unscrew the hex coupling on the top of the Fixture Body (D) andremove the fixture hood from the cage.B. Remove the Styrofoam inside of the cage.Figure 1FixtureHoodCageRevisedDate:2017-11-23D Fixture Bodyx 1Styrofoam (Remove)Hex CouplingDSTEP 2 Install Bulbs and FinialAssembly-A. Insert bulbs onto sockets andscrew snugly into place.B. Place the fixture hood back ontothe cage and secure with the hexcoupling. Hand tighten untilsnug.C. Remover nipple, strut memberand waterproof washer from thefinial.D. Thread the nipple onto the hexcoupling and hand tighten untilsnug. Pass the strut member andwaterproof washer over the topend of the nipple and secure withthe finial. Hand tighten untilsnug.STEP 3 Installing the Crossbar Assembly-A. Pass the supply wires through the Crossbar Assembly (A). Attachthe Crossbar Assembly (A) to the Outlet Box with the head of theGreen Ground Screw facing you. Secure the Crossbar Assembly (A)with Outlet Box Screws (not included). Tighten until snugNote: Use the Alternate Shorter Mounting Screw (B) if yourinstallation requires a shorter mounting screw..AMounting Screwor Alternate ShortMounting ScrewOutlet Box Screws(not included)Supply Wireswith Ground WireOutlet BoxFigure 3Hex CouplingFixtureHoodStemBulb (notsupplied)SocketFinialWaterproof WasherStrut MemberNippleFigure 2