Quoizel QF5118C Installation Manual

Quoizel QF5118C Installation Manual Manual pdf 1 page image

For Style QF5118CInstallation Guide #IS-QF5118C1of2Please go to for product cleaning tips. Go to the selection.(1) A19 Medium Base 100W bulb Maximum, bulb not included.20-30 minutesIdentify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts arepresent. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Missing Parts? Contact your original place ofpurchase.www.quoizel.com Care + MaintenanceLight Source:Estimated Assembly Time:Preparation:Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.Warnings and CautionsTurn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We stronglyrecommend that a licensed, professional electrician perform the installation.Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.Package ContentsACrossbarAssemblyx 1BFixtureBodyx 12018 QuoizelInc. visit us on-line at www.quoizel.comSTEP 1 - Installing the Crossbar AssemblyA. Pass the supply wires from outlet box through the CrossbarAssembly (A). Attach the Crossbar Assembly (A) to the Outlet Boxwith the head of the Green Ground Screw facing you. Secure theCrossbar Assembly (A) with Outlet Box Screws (not included).Tighten until snug.Supply Wires withGround WireOutlet Box Screws(not included)Outlet BoxA Figure 1STEP 2 Test Fitting Ceiling Canopy toCrossbar Assembly-A.Ceiling Canopy totheCeiling CanopyceilingRemove mounting balls from the CrossbarAssembly (A). Fit the (D)Crossbar Assembly (A) and secure withmounting balls. Note: The(D) should be snug against the andthe mounting balls. If not, adjust the lengthof the nipple on the Crossbar Assembly (A)by unscrewing the preassembled hex nutand lock washer and then screwing themounting screws in or out of the crossbaruntil the correct length is achieved. Once theCeiling Canopy (D) is secure, remove themounting ball and Ceiling Canopy (D) andproceed to Step 3.Mounting ScrewHex Nut andLock WasherMounting BallADFigure 2STEP 4 Install the Fixture-A. Carefully tuck all wires into the outlet box and position the CeilingCanopy (D) over the outlet box. Align the holes in the Ceiling Canopy(D) with the mounting screws, then attach the Ceiling Canopy (D)using the previously removed mounting balls. Hand tighten untilsnug.Figure 4STEP 3 - Wire ConnectionsA. Wrap bare or green ground wire around green ground screw on thecrossbar, no less than 2 inches from the end of the wire. Tighten thegreen ground screw.B. Use standard wire connectors (not included) to make all wireconnections. Twist connectors until wires are tightly joined together.Wrap each connection with approved electrical tape and carefullystuff all the connected wires into the Outlet Box.Figure 3Green Ground Screwon the CrossbarWhite wirefrom outlet box White wirefrom fixtureBlack wire fromoutlet box (or Red)Black wirefrom fixtureBare, or GreenGround wirefrom outlet boxGround wirefrom FixtureMounting ScrewMounting BallADReleasedDate:2018-12-27

/ 2

Related manuals for Quoizel QF5118C