Package ContentsWarnings and Cautions1of2For Style RO8410IZTurn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We stronglyrecommend that a licensed, professional electrician perform the installation.Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.ACrossbarAssemblyx 1Please go to for product cleaning tips. Go to the selection.(1) A19 Medium Base Bulb 100W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.20-30 minutesIdentify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts arepresent. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.www.quoizel.com Care + MaintenanceLight Source:Estimated Assembly Time:Preparation:Fixture can only be mounted in the direction indicated on page 2.Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.Fixture Bodyx 1 CInstallation Guide #IS-RO8410IZ2018 QuoizelInc. ReleasedDate:2018-09-13visit us on-line at www.quoizel.comBAlternateMounting screwx 2STEP 1 Remove Papers Inside of the Cage-A. Rotate the bolt and remove it from the bolt holder to open the door.B. Remove papers inside of the cage.C. Close the door and place the bolt back onto the bolt holder.Figure 1DoorBoltBolt HolderPaper(Remove)Figure 2STEP 2 Installing the Crossbar Assembly-A. Pass the supply wires through the Crossbar Assembly (A). Attachthe Crossbar Assembly (A) to the Outlet Box with the head of theGreen Ground Screw facing you. Secure the Crossbar Assembly (A)with Outlet Box Screws (not included). Tighten until snugNote: Use the Alternate Shorter Mounting Screw (B) if yourinstallation requires a shorter mounting screw..Supply Wireswith Ground WireOutlet Box Screws(not included)Outlet Box AMounting Screwor Alternate ShortMounting ScrewSTEP 3 Test Fit the Backplate to the Crossbar Assembly-A. Remove the mounting balls from the Crossbar Assembly (A). Placethe backplate and Fixture Body (C) onto the Crossbar Assembly (A)and secure with mounting balls. Note: The backplate and FixtureBody (C) should be snug against the wall and held tight with themounting balls. If it is not, adjust the length of the mounting screwson the Crossbar Assembly (A) by unscrewing the preassembled hexnut and lock washer and then screwing the mounting screws in orout of the crossbar until the correct length is achieved. Once thebackplate and Fixture Body (C) is secure, remove the mounting balland Fixture Body (C) and proceed to Step 4.Figure 3Mounting BallABackplateHex Nut andLock WasherCMounting Screwor Alternate ShortMounting Screw