Package ContentsWarnings and Cautions1of2For Style RO9018ACTurn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We stronglyrecommend that a licensed, professional electrician perform the installation.Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.Please go to for product cleaning tips. Go to the selection.marking pen, 1/16”drill bit, center punch, hammer, drill and wrench.(1) A21 Medium Base Bulb 150W Maximum, Medium Base Vintage Bulb is recommended, bulb not included.20-30 minutesIdentify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts arepresent. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact your original place of purchase.www.quoizel.com Care + MaintenanceLight Source:Estimated Assembly Time:Preparation:Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses,Armx 1CInstallation Guide #IS-RO9018AC2018 QuoizelInc. ReleasedDate:2018-09-13visit us on-line at www.quoizel.comLock Ballx 4BA Mounting Screwx 3DSide Rodx 2Fixture Bodyx 1ESTEP 1 Remove Papers Inside of the Cage-A. Rotate the bolt and remove it from the bolt holder to open the door.B. Remove papers inside of the cage.C. Close the door and place the bolt back onto the bolt holder.Figure 1STEP 2 Install Arm and Side Rods-A. Place tabs on the ends of the Arm (D) over bolts on the FixtureBody (E) and secure with Lock Balls (C). Hand tighten until snug.B. Thread Side Rods (B) onto the Fixture Body (E) and hand tightenuntil snug.DCBETabBoltFigure 2DoorBoltBolt HolderPaper(Remove)STEP 3 - Mark the Location for the 3 Mounting HolesA. Place the light fixture onto the post and mark the location of the 3mounting holes on the fixture fitter onto the post with the markingpen.FixtureFitter Marking PenMountingHolePostLightingPostPostFixtureFitterFigure 3