6Lift and mount each side panel onto the sides of the stove. Attach the back to the stove,and place the soapstone top plate on the top of the stove. Refer to the picture next page.Mount the special RAIS collar using the included hardware. When installing the first pieceof pipe (at the stove), place the pipe over the collar, which is designed so any moisture orcreosote will drip back into the stove and burn away. If using a crimped pipe, cut thatsection off at the bottom and place it over the collar. Install the remaining stovepipesegments with the crimped end down whenever possible.ChimneyThe RAIS stoves must be installed using a Class A UL 103 HTapproved factory-built chimney system or a code-approvedmasonry chimney with a flue liner. In Canada, the installationmust conform to CAN/CSA-B365.The chimney must extend through the roof at least 3’ (1m),and 2’ (.6m) above any structure within 10’ (3m).The condition of the chimney and height is very important. Wesuggest a total minimum height of 10’ (3m).Do not connect this stove to a chimney flue servinganother appliance.B.A.E.F.C.D.B.Reguired Installation ComponentsA. Chimney CapB. Insulated ChimneyC. Storm CollarD. Roof FlashingE. Ceiling Support Box or Joist Shield/Firestop SpacerF. Chimney Connector Pipe