RAIS RINA Instructions For Installation, Use And Maintenance Manual

Also see for JUNO: User manual User manual Instructions for installation, use and maintenance Instructions for installation, use and maintenance Instructions for installation, use and maintenance

Contents

ENGLISH RAIS - manual for Rais Rina, Rais Viva & Rais Juno14Chimney FiresIf the chimney is thoroughly and regularly swept, chimney fires should not occur.However, if a chimney fire does occur turn off the stove immediately and isolatethe mains electricity supply (if applicable), and tightly close the doors of the stove.This should cause the chimney fire to go out. If the chimney fire does not go outwhen the above action is taken then the fire brigade should be called immediately.Do not relight the stove until the chimney and flueways have been cleaned andexamined by a professional.Permanent air ventThe stove requires a permanent and adequate air supply in order for it to operatesafely and efficiently.In accordance with current Building Regulations the installer may have fitted apermanent air supply vent into the room in which the stove is installed to providecombustion air. This air vent should not under any circumstances be shut off orsealed.USER OPERATING INSTRUCTIONS - WOODPlease read the important notices given above before referring to the maininstruction book for detailed operating instructions.HETAS Ltd ApprovalHETAS approval may be limited to specific fuel types as detailed in the maininstruction manuals. Approval does not cover the use of other fuels either alone ormixed with the recommended fuel, nor does it cover instructions for the use ofother fuels.Recommended fuelsStoves may be designed to burn dry seasoned wood logs and/or solid mineral fuelas indicated in the main stove manuals.Door operationThe door handle may become hot during operation, use the tool to open and close thedoors, if appropriate.Lighting of firePlace some firelighters or paper and dry kindling wood on the grate and cover witha small amount of fuel. Set air controls to maximum and set light to firelighters orpaper. Close the doors and allow fire to burn until fuel is well alight then load withmore fuel and adjust air controls to the required level of heat output.Before relighting the fire clean the firebed of ash and clinker and empty theashpan.