RAM 3500 2012 User Manual

Also see for 2012 5500 Chassis Cab: User guide

Contents

RAM 3500 2012 User Manual Manual pdf 55 page image

PROGRAMMABLE FEATURESElectronic Vehicle Information Center (EVIC)• The EVIC can be used to view or change the following settings. Press the UPor DOWN button until System Setup displays, then press the SELECTbutton. Scroll through the settings using the UP or DOWN buttons. Pressthe SELECT button to change the setting. Press the BACK button to scrollback to a previous menu or sub menu.• Select Language • Headlamp Off Delay• Nav-Turn By Turn • Headlamps With Wipers• Auto Unlock Doors • Easy Exit Seat• Remote Unlock Sequence • Tilt Mirror In Reverse• RKE Linked To Memory • Key-Off Power Delay• Remote Start Comfort Sys. • Illuminated Approach• Horn With Remote Start • Compass Variance• Sound Horn With Lock • Calibrate Compass• Flash Lamps With LockKey Fob Programmable Features• The following features may also be programmed by using the Key Fobtransmitter or the ignition switch and driver's door lock switch.NOTE: Pressing the LOCK button while you are inside the vehicle will activate theVehicle Security Alarm. Opening a door with the Vehicle Security Alarm activatedwill cause the alarm to sound. Press the UNLOCK button to deactivate the VehicleSecurity Alarm.Unlock On First Press• To unlock either the driver's side, or all doors, on the first press of theUNLOCK button:• Press and hold the LOCK button for at least 4 seconds, but no longer than10 seconds. Then, press and hold the UNLOCK button while still holding theLOCK button.• Release both buttons at the same time.Auto Unlock Doors On Exit• To have all of the vehicle doors unlock when any door is opened:• Enter your vehicle, close all the doors and fasten your seat belt.• Within 15 seconds, cycle the ignition switch from the OFF position to the ONposition a minimum of five times, ending in the ON/RUN position (do not startthe engine).• Within 30 seconds, press the driver’s door lock switch in the UNLOCKdirection. A single chime will indicate that programming is complete.ELECTRONICS53