RAMSET GYPFAST AIR Operator's Safety & Operating Instruction Manual

Also see for GYPFAST: Instruction manual

Contents

RAMSET GYPFAST AIR Operator's Safety & Operating Instruction Manual Manual pdf 5 page image

TOOL LOADINGLOADING AND UNLOADING NAILS1 Lay the tool on its right side, exposing thegate latch2 Unlatch and open the gate Swing open themagazine cover3 Uncoil 3” of nails4 Guide the first nail into the drive raceway whileplacing the coil of nails into the magazine5 Close the magazine and gate and you are nowready to start driving nailsTo unload nails from a tool, first tear off excesscollation sticking out the front of the tool Unlatchand open the gate to remove the rest of the coilTOOL OPERATIONOPERATION OF TOOLThis tool is equipped with a safety yoke, whichmust be pushed to the work surface for the toolto operate when the trigger is actuated Twomethods of tool actuation are:1 Single Shot Operation. This method of operat-ing the tool is used when precise fastener loca-tion is more important than speed of operationPress the safety yoke against the work surface,then pull the trigger to drive the fastener2 Bump Fire or Contact Operation. This methodof operating the tool is used when speed ofoperation is more important than precise fastenerlocation Pull and hold the trigger, then strike thesafety yoke against the work surface where thefastener is to be driven Repeat this action asrapidly as requiredTO PREVENT UNINTENTIONAL TOOL OPERATIONAND POSSIBLE INJURY TO YOURSELF ORANYONE IN THE WORKING AREA, BE SURE TORELEASE THE TRIGGER AS SOON AS YOU HAVEFINISHED DRIVING FASTENERSNEVER PRESS THE SAFETY YOKE AGAINSTANY OBJECT EXCEPT THE MATERIAL TO BEFASTENEDAs the nails are being driven, the leftover collationis fed through the nose of the tool As collationaccumulates, it can be torn off by twisting andpulling down on the collation Keep your fingeroff the trigger when performing this procedureTOOL LOADING / TOOL OPERATION5TOOL LOADING / TOOL OPERATION

/ 8

Related manuals for RAMSET GYPFAST