RBI FUTERA FUSION Series Installation & Operation Manual

Also see for FUTERA FUSION CB-1000: Installation and operation instructions

Contents

RBI FUTERA FUSION Series Installation & Operation Manual Manual pdf 38 page image

38FUTERA III / FUSIONSTARTUP SHEETDATE: JOB NAME:TECHNICIAN: LOCATION:COMPANY: MODELPHONE NUMBER: SERIAL #:PRE-STARTUP CHECK LISTNO VISUAL DAMAGE TO UNITPIPING PROPERLY CONNECTEDBOILER CIRCULATOR WIREDVENT/STACK CONNECTEDINLET AIR FILTER INSTALLED AND CLEANPROPER SERVICE CLEARANCE PROVIDEDPUMP RUNNING, HEAT EXCHANGER FULLGAS LINES PURGED, NO LEAKS, NO MISSINGTEST PLUGSBOILER STARTUP SEQUENCENote: Locate the AA terminals in the bottom-right of the electrical panel on the control relay board and the min-holdswitch located on the display board. Also locate the gas pressure tapping upstream of the main gas valve.1. Cycle boiler and hold at trial for pilot ignition.2. Set pressure to 2 - 2.5" W.C. (Flame signal should read 5.0 V DC)3. Cycle boiler to main flame trial for ignition.4. Place boiler to min hold (33%).5. Record combustion and elbow pressure. (Reference factory start-up sticker)6. Release boiler from min hold to run. (Jumper AA terminals for 100% input)7. Record combustion and elbow pressure. (Reference factory start-up sticker)8. Check all combustion results using a calibrated flue gas analyzer.COMBUSTION ANALYSIS 33% FIRE 100% FIREGAS PRESSURE (IN. W.C.)CO 2O 2CO (PPM)NET STACK TEMP.9. Remove jumper at terminals AA and release boiler to RUN mode.

/ 40

Related manuals for RBI FUTERA FUSION CB-1000