SPECTRUM INSTALLATION AND OPERATING INSTRUCTIONSPage 20WARNING: If you do not follow these instructions exactly, a fire or explosion may result causingproperty damage, personal injury or loss of life.FOR YOUR SAFETY READ BEFORE LIGHTINGA. If this appliance is equipped with a continuouspilot, it must be lit by hand. Follow the lightinginstructions exactly.B. BEFORE LIGHTING smell all around the appliance areafor gas. Be sure to smell next to the fl oor because somegas is heavier than air and will settle on the fl oor.C. Use only your hand to push in or turn the gascontrol knob. Never use tools. If the knob will not pushin or turn by hand, don't try to repair it, call a qualifi edservice technician. Force or attempted repair may re-sult in a fi re or explosion.D. Do not use this appliance if any part has been underwater. Immediately call a qualifi ed service technician toinspect the appliance and to replace any part of thecontrol system and any gas control that has been underwater.LIGHTING INSTRUCTIONS1. STOP! Read the safety information above.2. Set the thermostat to lowest setting.3. Remove control access panel.4. Push in gas control knob slightly and turn clock wiseto “OFF”,5. Wait fi ve (5) minutes to clear out any gas. Then smellfor gas, including near the fl oor. If you smell gas, STOP!Follow “B” in the safety information above (to the left)on this label. If you do not smell gas, go to the next step.6. Open the pilot sight door above the main burners.7. Find pilot – follow metal tubefrom the gas control. Thepilot is between the two burnertubes behind the pilot sight door.8. Turn knob on gas control counterclockwise to“PILOT”.9. Push in control knob all the way and hold in. Immediatelylight the pilot with a match. Continue to hold the controlknob in for about one (1) minute after the pilot is lit. Re-lease knob and it will pop back up. Pilot should remainlit. If it goes out, repeat step 4 through 9.• If knob does not pop up when released, STOP andimmediately call your service technician or gassupplier.• If the pilot will not stay lit after several tries, turn thegas control knob to “OFF” and call your servicetechnician or gas supplier.10. Close pilot sight door.11. Turn gas control knob counterclockwise to “ON”12. Replace control access panel.13. Set thermostat to desired setting.PILOTONOFFGAS CONTROL KNOBRED RESET BUTTONPRESSURE REGULATORADJUSTMENT (UNDERCAP SCREW)OUTLET PRESS. TAPGAS INLET GAS OUTLETTO TURN OFF GAS TO APPLIANCE1. Set the thermostat to lowest setting.2. Remove control access panel.3. Push in gas control knob slightly and tur nclockwise to “OFF”. Do not force.4. Replace control access panel.DANGER: Propane gas may not always be detectedby smell. Propane gas is heavier than air and cancollect in low areas.Propane gas can ignite or explode if an ignitionsource is present and result in death, serious injuryand property damage!FOR YOUR SAFETY:• Have only qualified licensed professionals install,service and maintain this appliance and your gassystem in accordance with all applicable codes.• Install a nationally listed combustible gas detector(s)in your home.• If you suspect a leak:1. Have everyone leave the building immediately.2. Do not attempt to light any appliance.3. Do not touch any electrical or electronic switchesin the building.4. Do not use any phone in the building.5. Call your gas supplier from a phone outside ofthe building.6. If you cannot reach your gas supplier call the fi redepartment.