Chapter 1: Connections & Setup14 Chapter 1Complete the Initial SetupThe menu systems in your TV/DVD allow the unit’s features to work properly. You’ll need to set a fewimportant menu items the first time you turn on your TV/DVD.Complete Auto Channel SearchThis part of the setup allows the TV to search for all channels viewable through yourantenna or cable TV system. This is called auto channel search.1. Make sure the remote is in the TV mode by pressing the TV button.2. Press MENU (the Main menu appears).3. Press the down arrow button until SETUP is highlighted, and press ENTER (theSETUP menu appears).4. Press the down arrow button until ANTENNA INPUT is highlighted, and pressENTER (the ANTENNA INPUT menu appears).5. Press the down arrow button to highlight AIR (for an off-air antenna) or CABLE,HRC, or IRC (cable systems) depending on the type of signal you have. Then pressENTER.Note: Contact your cable company if you’re not sure which system you have.6. Press MENU again (the Main menu appears); press ENTER to select the SETUPmenu.7. Press the down arrow button until AUTO CH. SEARCH is highlighted, and pressENTER to begin the auto channel search. This may take several seconds.Once the search is complete, you can begin watching TV. To add or delete any channels,go to page 35.MAIN MENUCLOSED CAPTIONPICTURESOUNDSETUPPARENTAL CONTROLSETUPADDERASEAUTO CH. SEARCHANTENNA INPUTTipYou can also program the available channels bypressing the AUTO CH. SEARCH button on theremote. You still need to set the ANTENNA INPUTin the menu for the type of signal you have first,however.ANTENNA INPUTAIRCABLEHRCIRC1628714C_1_C&S 8/27/04, 10:00 AM14
