RCA 20F542T User Manual

Also see for 27F520T - 27" TruFlat Picture Tube TV: Specifications Guía del usuario Guide de l'utilisateur

Contents

RCA 20F542T User Manual Manual pdf 6 page image

5Basic Antenna ConnectionA combination antenna receives normal broadcast channels (VHF -1 AND UHF 14-69). Your connection is easy sinceyou will connect the antenna to the 75 OHM ANTENNA INPUT jack on the rear of the TV.If your antenna has a round cable (75 ohm) on the end, then you are ready to connect it to the TV. Go to the next step.If your antenna has flat twin-lead wire (00 ohm), you first need to attach the antenna wires to the screws on a 00 to75 ohm adapter (not supplied with your TV).Push the round end of the adapter or antenna cable onto the 75 OHM ANTENNA INPUT jack on the rear of the TV. Ifthe round end of the antenna cable is threaded, screw it down tight.Plug the TV’s power cord into a power outlet and turn on the TV. Set TV/CATV to TV mode as detailed on page 1.Refer to AUTO SEARCH to set up your available TV channels. Details are on page 1.FCC WARNING -This equipment may generate or use radiofrequency energy. Changes or modifications to this equipmentmay cause harmful interference unless the modifications areexpressly approved in the instruction Manual. The user couldlose the authority to operate this equipment if an unauthorizedchange or modification is made.CABLE TV / ANTENNA CONNECTIONSBefore plugging the UHF/VHF Rod Antenna into theANTENNA INPUT jack, check that the pin is not bent. Ifit is bent, straighten the pin as illustrated, then plug thepin into the jack.(Straight pin)PlugCableBent pin(Needs to be straightened)*Some cable TV systems use scrambledsignals and require a special converter toreceive these channels. Consult your localcable company.UHFAntenna(Not supplied)VHFAntenna(Not supplied)VHF/UHFCombination Antenna(Not supplied)VHF/UHFCombiner(Not suppliedANT. INOR ORCATV Box*or Satellite Box(Not supplied)From Cable Systemor Satellite Antenna75-ohmCoaxial CableOUT INFrom Cable System75-ohmCoaxial CableNote to CATV system installer:This reminder is provided to call the CATV system installer’s attention to Article 80-40 ofthe NEC (Section 54 of the Canadian Electrical Code, Part 1) that provides guidelines forproper grounding and, in particular, specifies that the cable ground shall be connected tothe grounding system of the building as close to the point of cable entry as practical.Helpful HintsIf you have separate UHF andVHF antennas, you need anoptional combiner to connectthe antennas to the TV.