RCA 27F501TDVB User Manual

Contents

Remote control (continued)inserting BatteriesOpen the battery 2 Install two"AAA" batteries 3 Replace the compartmentcompartment cover in the (supplied), paying attention to the cover.direction of the arrow, polarity diagram in the batterycompartment.Battery precautionsThe precautions below should be followed when using batteries in this device:1. Use only the size and type of batteries specified.2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the "-" end first.3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury frompossible battery leakage.5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow batterymanufacturer's directions.)Remote control basics, Press POWER to turn the TVNCR/DVD on or off., Select your desired operating mode (TV/VCR or DVD) using TV/VCR or DVD., Press CH +/- to move through the channels one channel at a time., The Arrow buttons (A/V/, / •) are also used to navigate on-screen menu system., You can directly access specific channels using the number buttons.Operation, Aim the remote control at the remote sensor and press controlbuttons to operate., Operate the remote control within a 30 ° angle on either side of theremote sensor, up to a distance of approximately 5 meters (16 ft.).approximately5 meters (16 ft.)10