Co meetio s getupG-LINK wandsWhy You Should Connect This G-LINK CableThe G-LINKcable enables the GUIDEPlus+system (the on-screen interactiveprogram guide) to work with your VCRand/or cane boxCable Box - If your IV is connected to a cable box you must connect theG-LINK cable to receive IV program listings for your area, and to tunedirectly to a channel when the program guide is on your TVscreen.VCR - If your IV is connected to a VCRand you don't connect the G-LINKcane, one-touch VCR recording won't work The other features of the guidewill work properly.How to Find the Remote SensorYou have to place the G-LIN K wands in front of the remote sensor on the VCR and/or cable box. Some cable boxes and VCRs have the remote sensor labeled on theunit. If the remote sensor isn't labeled on your VCR andtor cable box, you need touse the remote control that came with the VCR and/or cable box to locate thesensor.1. Turn off the VCR and/or cable box.2. Hold the remote control (not the one that came with your IV, but the one thatcame with the cable box andtor VCR to which you're attaching the G-LINKcable) so that it is touching the front of the component.3. Slowly move the remote control across the front of the component (VCR orcable box) while you press the power button on and off. You must press andrelease the power button each time you move the remote (holding down thebutton won't work).4. When the component turns on, you've located the remote sensor.Placing the G-LINK WandsPlace the G-LINK wands in front of the remote sensor on your VCR and/or cablebox approximately one inch away from the remote sensonChapter 1 Graphics contained within this publication are for representation only. 7