Chapter 2 9Graphics contained within this publication are for representation only.Chapter 2: Using the Remote ControlButton Descriptions for TV ModeArrows Used to point to different items in the TV menu and to adjust the menucontrols.Indicator Indicates the programming mode when programming the remote tocontrol components. Lights when you press a valid button on the remote. Flickerswhen a button is pressed and the batteries are low.(0-9) Number Buttons Enter channel numbers and time settings directlythrough the remote control.To enter a one-digit channel, enter a zero first. To enter a two-digit channel, pressthe two digits and expect a few seconds delay. This is in case you want to enter athird digit.CC Toggles closed captioning on and off.CH + or CH - Scans up or down through the current channel list. Press once tochange the channel up or down; press and hold to continue changing channels.CLEAR Removes any menu or display from the screen and returns you to normalviewing.GO BACK Returns you to the previous channel.INFO Brings up channel banner; press again to clear the screen.INPUT Toggles through the available input sources (VID1/SVID1, VID2/CVID2,CVID3, FRNT, and current channel).MENU Brings up the Main menu.MUTE Reduces the TV’s volume to its minimum level. Press again to restore thevolume.OK When in the menu system, selects highlighted items.ON•OFF When in TV mode, turns the TV on and off. If in another mode (VCR,DVD, SAT•CAB, etc.), will turn the component on and off.PRESETS Picture options are reset to original factory settings.SKIP Press once before changing channels and the TV will go back to the originalchannel after 30 seconds. Press repeatedly to add more time.TV Turns on the TV and puts the remote in TV mode. Also displays current status.VOL – or VOL + Decreases or increases the TV’s volume.Button Descriptions for Other ModesAUDIO Places the remote in audio mode to operate a component (such as anaudio receiver, or amplifier receiver) that you’ve programmed to work with thisbutton.AUX Puts the remote in AUX mode. Can also be programmed to operate mostbrands of an additional remote-controllable component.ANTENNA In VCR mode, functions as a TV/VCR button. In SAT•CAB mode,functions as a TV/receiver button.DVD Puts the remote in DVD mode and, if auto tuning is enabled, will turn on theTV and tune to the correct video input channel.ON-OFFTVDVD VCRSATïCAB AUX AUDIOCLEARCC INFOMENUOKPRESETS SKIPGUIDEVOL CHMUTE GOBACK1 2 34 5 67 8 90INPUT ANTENNAREVERSE PLAY FORWARDRECORD STOP PAUSEIndicator