Tuning To Analog ChannelsAn analog channel has a channel number beginning with “A”. Input the digital number with numeric buttons directly and pressENTER button to confirm.For example, to watch analog channel “A51”, press “5”, “1”, “ENTER” on remote control in sequence.Adjusting TV Stand AngleThe TV cabinet can manually adjust to left or right for 15 degrees from the centre.You can adjust the angle for the best viewing effect and comfort.Tuning To Digital ChannelsNote: Although there is no analog TV signal available in America, we reserve ATV functions for some expansible use.A digital channel has a channel number beginning with “D”. Input the main digital number with numeric buttons directly, then press“ ” button on remote control, and input the sub number at last.For example, to watch analog channel “D31-1”, press “3”, “1”, “ ” button. “ENTER” on remote control in sequence.You can use CH button to increase channel number and CH to decrease channel number. When no OSD (On ScreenDisplay) is used, the up/down arrows can also work as CH /CH buttons.Press INPUT button on remote control to display Source Select list.Use up/down arrows to highlight the source you need and press ENTER to confirm.Changing Channels DirectlyBasic OperationsTurning On and OffChoosing TV ChannelSelecting Input SourceConnect the AC cord to power the LED LCD TV. At this time the TV will enter standby mode and power indicator shows red.Use Power button ( ) on the top panel of TV or on the remote control to turn on the TV. After switching off the TV for 5 seconds,you can turn on TV again.21Source SelectTVAVHDMI 1ComponentHDMI 2HDMI 3HDMI 4PC