THE BASIC CONNECTIONTV and VCRSATELLITEIDISH ANTENNATV7CABLE ORANY ALTERNATERF SIGNAL, SUCH ASA DIGITAL OR ANALOGTERRESTRIAL ANTENNA1DIGITALPHONE AUDIO OUTJACK[] ®ANTENNA8CABLE OROFF-AIR ANTENNAVCRtN FROMANT CHHow to view programming:To watch cable TV or off-air TV programsfrom an antenna in this connection, pressANTENNA on the remote control untilANTENNA A is displayed in the channelbanner.To watch cable or any other alternate RFsignal, such as digital or analog terrestrial,press ANTENNA on the remote controluntil ANTENNA B is displayed in thechannel banner.To watch satellite programming, pressDIRECTV on the remote control andchannel up or down to the desiredprogram.How to view your VCR:Press INPUT on the remote control andselect the video input (in this example,VID1) in the channel banner. Because thedigital decoder is in the TV, not the VCR,digital channels cannot be recorded. If anoff-air antenna is used, the VCR outputshould be viewed using one of the videoinputs.• If you've already set up auto tuning, pressthe VCR1 button on your remote control.NOTE: Viewing a VCR while in AIR modemay result in poor picture performance.Instead, select System Optionsfrom themain menu, then select Signal Type andselect Cable.The ANT B and ANT A jacks can receive |digital or analog RF signals. The1illustrations here are recommendedconnections in a cable environment.I Some cable systems may require a 1"conversion box." If so, consult your cablecompany's box tuning instructions fordetails.12