Connections & Setup10 Chapter 1Removing the Front Panel PieceThe front panel piece is removable to allow access to the jack panel, mirror adjustment screws, and lamp door. The mirroradjustment is discussed on page 59 and the lamp replacement is discussed on page 76. To remove the front panel piece,grasp one end of the panel and pull out until the tab pops out of the hole. Continue to slide your fingers down the panel asthe tabs pop out of place, until it is unattached. Reattach the front panel piece by lining up the tabs with the holes, startingat the bottom. Then push the tabs back into place.Jack panel door Front panel pieceJack panel shelfFront panel pieceAccessing the Jack PanelThe jack panel is located towards the back of the TV. You can access thesejacks from the front by removing the front panel piece as described above, orfrom the back by removing the jack panel door.Locate the jack panel door on the back of the TV on the right bottom side. Toremove the door, pull the tab towards the left, and then pull the door open.Reattach the jack panel door by fitting the tabs on the left into the slots andthen close the door until it snaps into place.Connect the cables to the jacks by putting the cables through the hole, asshown to the left. Then the cables can be placed on the shelf at the back of theTV.Mirror adjustment screws Lamp doorTabholesJack panel access
