RCA F27718, F32718, F36718, MR68R718 User Manual

Also see for F27TF720: Technical specifications User guide User guide

Contents

RCA F27718, F32718, F36718, MR68R718 User Manual Manual pdf 16 page image

14 Chapter 1Connections & SetupVCR03CHANNELCABLE BOXTipIf you don’t have both acable box and a VCRconnected to your TV, justcoil the cable of the extraG-LINK wand with a twisttie and leave it behind theTV.G-LINK wandsG-LINK cablePbPrR-AUDIO-LVIDEOYCABLE/ANTENNAS-VIDEOG-LINKR LFrom Cable,Cable Box,or AntennaINPUT1R-AUDIO-LVIDEOINPUT2AUDIOOUTVCR03CHANNELSENSORSENSORConnect to G-LINK jackon the back of the TV.TV (back panel)V-PORTWhy You Should Connect This G-LINK CableThe G-LINK cable enables the GUIDE Plus+ system (the on-screen interactive program guide) towork with your VCR and/or cable box.Cable Box – If your TV is connected to a cable box you must connect the G-LINK cable toreceive TV program listings for your area, and to tune directly to a channel when the programguide is on your TV screen.VCR – If your TV is connected to a VCR and you don’t connect the G-LINK cable, one-touchVCR recording won’t work. The other features of the guide will work properly.How to Find the Remote SensorYou have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable box.Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn’tlabeled on your VCR and/or cable box, you need to use the remote control that came with the VCRand/or cable box to locate the sensor.1. Turn off the VCR and/or cable box.2. Hold the remote control (not the one that came with your TV, but the one that came with thecable box and/or VCR to which you’re attaching the G-LINK cable) so that it is touching thefront of the component.3. Slowly move the remote control across the front of the component (VCR or cable box) whileyou press the power button on and off. You must press and release the power button each timeyou move the remote (holding down the button won’t work).4. When the component turns on, you’ve located the remote sensor.Placing the G-LINK WandsPlace the G-LINK wands in front of the remote sensor on your VCR and/or cable box approximatelyone inch away from the remote sensor (see instructions below).