Step 1: Unpack the TVMake sure to locate the remote control.Step 2: Connect Your TVThere are three types of connections outlined in this section:TV Only:The Basic Connection:If you're only going to connect theTV to your home antenna or cablesystem.If you're going to connect theTV to aVCR or satellite receiver.Advanced Connections: If you're going to make multipleconnections, hooking up theTV to aVCR and a satellite receiver.Cable information and illustrations are given for each type ofconnection. Once you have completed your desired connectionyou may skip forward to Step 3.TV OnlyThis is a basic connection from an antenna or cable system toyourTV. Connect the cable into the Cable/Antenna jack as shown.CablesYou will use the following cable to make your connection:Coaxial Cable:These cables carry audio andvideo signals to theTV from an antenna,cable, or cable box.Important Stand Information -'CAUTION: Choose the location foryour TV carefully. Take precautionsthat the stand or other furniture onwhich the TV is placed is properlylocated (see Important Safeguardssheet) and of adequate size andstrength to prevent the TV fromaccidentally being tipped over,pushed off, or pulled off. This couldcause damage to the TV and/orpersonal injury.Before You ConnectProtect against power surges:• Connect all components beforeplugging any power cords into thewall outlet.• Turn off the TV and/or componentbefore connecting or disconnectingany cables.• Make sure all antennas and cablesare properly grounded. Refer to theImportant Safeguards sheetpacked with your TV.CABLE, CABLE BOX, OR ANTENNATVCONTROL5kVIDEOI Once you have completed this 1connection you may skip to Step 3.4