RCA HD52W59 User Manual

Also see for hd52w59: Specification sheet Quick start guide

Contents

RCA HD52W59 User Manual Manual pdf 56 page image

Other Information54 Chapter 5TroubleshootingMost problems you encounter with your TV can be corrected by consulting the following troubleshooting list.Note for U.S. customers: If you prefer, we can provide you with the name of an Authorized Service Representative who will visityour home for a fee to install your electronic entertainment system and to instruct you in its operation.TV ProblemsTV won’t turn on• Press the TV button.• Make sure the TV is plugged in.• Check the wall receptacle (or extension cord) to make sure it is “live” by plugging in something else.• Something might be wrong with your remote control. Press the POWER button on the front of the TV. If the TV turns on, check theremote control solutions on the next page.• The front panel controls may be locked (disabled). Use the remote control to unlock the front panel controls by selecting the FrontPanel Block in the Parental Control menu and press OK to uncheck the box.• The TV might be performing a periodic diagnostic check. Wait for a few minutes for the TV to turn on.Buttons don’t work• If you’re using the remote control, press the TV button first to make sure the remote is in TV mode.• The front panel controls may be locked (disabled). Use the remote control to unlock the front panel controls by selecting the FrontPanel Block in the Parental Control menu and press OK to uncheck the box.• Unplug the TV for ten minutes and then plug it back in. Turn the TV on and try again.TV turns off unexpectedly• Sleep timer may have been activated. Go to page 47 for instructions.• Electronic protection circuit may have been activated because of a power surge. Wait 30 seconds and then turn on again. If thishappens frequently, the voltage in your house may be abnormally high or low.• Unplug the TV. Wait ten minutes. Then, plug the TV in again.TV turns on unexpectedly• Wake up timer might have been activated. Go to page 47 for instructions.• Auto on might have been activated. Go to page 47 for instructions.• You might have pressed CH+, CH- or INPUT on the remote accidentally.Blank screen• If you're trying to watch TV, change channels or press the ANTENNA button to switch tuners.• If you're trying to watch something that's playing on a component connected to the TV (like a DVD or a VCR tape), press the TVbutton on the remote, then press INPUT until you get to the correct video input channel.• If you're trying to watch a component (like your DVD player or VCR), make sure the component connected to the TV is turned on.• If you're trying to watch a component (like your DVD player or VCR), make sure the component is connected correctly.No sound, picture okay• Maybe the sound is muted. Try pressing the volume up button to restore sound.• If using S-Video or Y PB PR, remember to also connect the component’s left and right audio output jacks to the TV’s L and R AudioInput jacks.• The sound settings may not be set correctly. Go to page 42 for more information.