3Internet SettingsDHCP setting1. Press the SETUP button on the remote. The Setup menu appears.2. Use the arrow buttons to highlight the Ethernet option, then press OK.3. Use the arrow buttons to highlight the DHCP option, then press OK.4. Set the DHCP option to On, then press OK.5. Set the DNS option to On, then press OK.6. Select Confirm, then press OK. Confirming starts.7. If the setup is successful, an IP address appears. Press the OK button.If the setup is not successful:1. Set the DHCP option to Off then press OK.2. Input the addresses into IP address, Subnet Mask and Gateway using thenumber buttons.Refer to the table on the next page.3. Set the DNS option to Off then press OK.4. Input the address into DNS Server.5. Press OK. Confirming starts.DHCPDHCPIP AddressSubnet MaskGatewayDNSDNS ServerOKOnCancel0 . 0 . 0 . 00 . 0 . 0 . 00 . 0 . 0 . 00 . 0 . 0 . 0ConfirmOffOn OffDHCPDHCPIP AddressSubnet MaskGatewayDNSDNS ServerOKOnCancel0 . 0 . 0 . 00 . 0 . 0 . 00 . 0 . 0 . 00 . 0 . 0 . 0ConfirmOffOn OffSkipped when“DHCP” is setto “On”.Skipped when“DHCP” is setto “On”.Proxy SettingProxyServerPortUserPasswordOK Cancela************On Offa0Proxy settingUse this setting only if your provider requires a proxy setting.1. On the Ethernet menu, press the arrow buttons to select Proxy setting, then press OK.2. Set the Proxy option to ON and press OK.3. Use the arrow buttons to input information into the Server, Port, User and Password fields.4. Select OK and press the OK button.User Name and Password1. On the Ethernet menu, use the arrow buttons to select the User Information option, thenpress OK.2. Select User and press OK.3. Use the up/down arrow buttons to input letters/numbers. Use the right/left arrow buttonsto move to a new position. Press OK.4. Select Password and press OK. Input your password using the arrow buttons as describedabove. Press OK.5. When your password is entered, Select OK and press the OK button.User informationUserPasswordOK Cancel************A