RCA J20F635 User Manual

RCA J20F635 User Manual Manual pdf 5 page image

Chapter 1 5Graphics contained within this publication are for representation only.Things to Consider Before You ConnectProtect Against Power Surges• Connect all components before you plug any of their power cords into the wall outlet.• Turn off the TV and/or component before you connect or disconnect any cables.• Make sure all antennas and cables are properly grounded. Refer to the Important Safeguardssheet packed with your TV.Protect Components from Overheating• Don’t block ventilation holes on any of the components. Arrange the components so that aircan circulate freely.• Don’t stack components.• If you place components in a stand, make sure you allow adequate ventilation.• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from itwon’t flow around other components.Position Cables Properly to Avoid Audio Interference• Insert each cable firmly into the designated jack.• If you place components above the TV, route all cables down the side of the back of the TVinstead of straight down the middle of the TV.• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twinlead cables away from audio/video cables.Important Stand and Base Safety InformationChoose the location for your TV carefully. Place the TV on a stand or base that is of adequatesize and strength to prevent the TV from being accidentally tipped over, pushed off, or pulled off.This could cause personal injury and/or damage the TV. Refer to the Important Safeguards sheetpacked with your TV.Use Indirect LightDon’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft orindirect lighting.Things to Consider Before You ConnectYou will need a master remote or ClonePRO™ to set up the TV. Go to the accessory page at theback of this manual or contact your RCA commercial distributor to purchase these.Chapter 1: Connections & Setup