RCA J22C760 User Manual

Contents

RCA J22C760 User Manual Manual pdf 7 page image

Graphics contained within this publication are for representation only.Chapter 1 7Chapter 1: Connections and SetupThings to Consider Before You Connect• Connect all devices before you plug any of their power cords into the wall outlet or power strip. NEVERplug your TV into an outlet that is controlled by a wall switch.• Turn off the TV and/or device(s) before you connect or disconnect any cables.• Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions atthe beginning of the User's Guide.Protect Against Power Surges• Don’t block ventilation holes on any of the devices. Arrange the devices so that air can circulate freely.• Don’t stack devices.• If you place devices in a stand, make sure you allow adequate ventilation.• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flowaround other devices.Protect Devices from Overheating• Insert each cable firmly into the designated jack.• If you place devices above the TV, route all cables down the side of the back of the TV instead of straightdown the middle.• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cablesaway from audio/video cables.Position Cables Properly to Avoid Audio InterferenceDon’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirectlighting.Use Indirect LightYou will need a master remote or USB Cloner to set up the TV. Contact your RCA Commercial Distributor topurchase these.Remote ControlCheck that the following parts were packed with your product.Check Supplied PartsPower Cord Owner’s ManualNote- If you need to replace your remote, call 800-RCA-2161. A shipping and handling fee, and the appropriatesales tax, will be charged upon ordering. Have your Visa, MasterCard, or Discover Card ready.- Stand Base, Stand Body images shown may differ from your TV."User must use shielded signal interface cables with ferrite cores to maintain standard compliance for the product"Stand Base(Optional)Stand Body(Optional)