Other InformationChapter 8 43Graphics contained within this publication are for representation only.The Remote Control Doesn’t Work• Something might be between the remote and the remote sensor on the component. Make sure there is a clear path.• Maybe the remote isn’t aimed directly at the component (TV or VCR) that you’re trying to operate.• Maybe remote is not in TV Mode. Press the TV button so remote will control TV.• Maybe batteries in remote are weak, dead, or installed incorrectly. Put new batteries in the remote. (Note, if you remove the batteries, you may have toreprogram the remote to operate other components.)• You might need to drain the remote’s microprocessor: remove batteries and press the number 1 button for at least 60 seconds. Release the 1 button,replace the batteries, and (if necessary) program the remote again.Problems with V-Chip/Parental ControlsThe rating limits don’t work• You must lock the settings. Go to the MAIN MENU (press MENU on your remote), select Parental Control, select Lock Parental Controls.I don’t remember my password and I want to unlock the TV• If you forget your password, press MENU, then select Parental Control (the password entry screen appears). Simultaneously press and hold CH+ and VOL+on the TV’s front panel for 3 seconds. The Parental control menu appears on the screen, and you can re-enter a password via Lock Parental Controls.The V-Chip won’t let me watch a program even though it’s not rated as violent.• Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set NR to View separately in order to view movies with anNR rating.Care and CleaningCAUTION: Turn OFF your TV/DVD before cleaning.You can clean the TV/DVD as required, using a soft lint-free cloth. Be sure to occasionally dust the ventilation slots in the cabinet to help assureadequate ventilation.The TV/DVD’s screen may be cleaned with a soft, lint-free cloth as well. Take care not to scratch or mar the screen. If necessary, you may use acloth dampened with warm water. Never use strong cleaning agents, such as ammonia-based cleaners, or abrasive powder. These types ofcleaners will damage the TV/DVD.While cleaning do not spray liquid directly on the screen, or allow liquid to run down the screen and inside the TV/DVD. Also, avoid placing drinks orvases with water on top of the TV/DVD. This could increase the risk of fire or shock hazard or damage to the TV/DVD.Caution: Using video games or any external accessory with fixed images for extended periods of time can cause them to be permanently imprinted onthe picture tube (or projection TV picture tubes). ALSO, some network/program logos, phone numbers, etc. may cause similar damage. This damage isnot covered by your warranty.Handling Cautions• Before connecting other components to this TV/DVD, be sure to turn all components off.• Don’t move the TV/DVD while a disc is being played. The disc may get scratched or broken, and the TV/DVD’s internal parts may be damaged.• Don’t put any container filled with liquid or any small metal objects on the TV/DVD.• Be careful not to put your hand into the disc tray.• Don’t place anything other than the disc in the disc tray.• Exterior influences such as lightning and static electricity can affect normal operation of this player. If this occurs, turn the TV/DVD off and onagain with the ON•OFF button, or disconnect and then reconnect the AC power cord to the AC power outlet. The TV/DVD will operate normally.• Be sure to remove the disc and turn off the TV/DVD after use.Formation of Condensation• Due to sharp changes in temperature and humidity, condensation may form if warm air comes in contact with any cold parts inside the TV/DVD.• When condensation forms inside the TV/DVD, it may not operate correctly. If this occurs, leave the TV/DVD at room temperature until the inside ofthe disc tray becomes dry and operational.• If condensation forms on a disc, wipe the disc with a soft, dry cloth by moving the cloth from the center hole toward the outer edge.