RCA L46FHD37R User Manual

Before/nitia/SetupProtect Against Power Surges• Connect all components before you plug any power cords into the wall outlet or power strip.NEVER plug your TV into an outlet that is controlled by a wall switch.• Turn off the TV before you connect or disconnect any cables.• Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions.Safety Information• Protect components from overheating.• Don't block ventilation holes on any of the components. Arrange the components so that air can circulate freely.• Don't stack components.• If you place the component in a stand, make sure you allow adequate ventilation.• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won't harmother components.Avoid Audio Interference• Position cables properly; insert each cable firmly into the designated jack.• If you place components above the TV, route all cables down one side of the back of the TV instead ofstraight down the middle.• If your antenna uses 300-ohm twin lead cables, do not coil the cables.• Keep twin lead cables away from audio/video cables.Avoid Direct LightDon't place the TV where sunlight or room lighting is directed toward the screen. Use soft or indirect lighting.Check Supplied PartsCheck that the following parts were packed with your product.Replacing your remoteIf you need to replaceyour remote, call1-800-257-7946. Ashipping and handlingfee, and the appropriatesales tax, will be chargedupon ordering. Pleasehave your Visa orMasterCard ready.6 1 i Connections and Setuponly for model L40FHD41orly for model L42FHD37R/L46FHD37Rf;_1 /7 I{f', (;o tll ;:t sd/fir _t 711(;/1> i_/1> o j